Russell Hobbs RH1261TW instruction manual Water inlet connection, Water discharge connection

Water inlet connection

Only a qualified engineer should install this machine

∙Your machine has a single water (cold) inlet.

∙To prevent leakages on the connection joints, 1 seal is included in the hose packing, (Fit this seal on the end of the water inlet hose at the tap side.)

∙Connect the bracketed end of the water inlet hose to the water inlet valve at the rear of the machine and the other end to your tap.

∙Water pressure of 0,1-1 MPa from your tap will enable your machine to work more efficiently, (0,1 MPa pressure means water flow of more than 8 litres in 1 minute from a fully opened tap).

∙After all connections are completed, check for leakages around the connection joints by turning on your tap completely and seeing if any water escapes.

∙Be sure that water inlet hose is not folded, broken or crushed.

∙Mount the water inlet hose to a 3”/4 geared water tap.

Water discharge connection

∙Be sure that the water inlet hoses are not folded, twisted, crushed or elongated by stretching.

∙The water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from the ground.

∙The end of the water drain hose can be fitted directly to the drainage hole.

∙Never attempt to extend the water drain hose by adding extra parts.

For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084 -9-