Installation
Water Connection
Ensure the machine is connected to a clean, cold running water supply.
Water inlet hose
Only use the water inlet hose supplied with this machine. Do not re- use old inlet hoses. Connect the water inlet hose directly to the water inlet tap. The pressure supplied by the tap should be a minimum of 0.03Mpa and a maximum of 1Mpa. If the water pressure is above 1Mpa, a pressure release valve should be fitted. After the connection is made, the tap should be turned on fully so the fitting is secure and there are no leakages. For the safety and maintenance of your machine, make sure you always turn off the water after using the machine.
Note:
Aquastop water spouts are used in some models. If it is there should be no excess tension in it, it is not cut and that it is not twisted.
Water Outlet Hose
The water drain hose can be connected either directly to the water drain hole or to the sink outlet spigot. Using a special bent pipe, the water can be drained directly into the sink via hooking the pipe over the edge of the sink. This connection should be a minimum of 50cm and at a maximum of 110 cm from the floor.
Note
If a drain hose longer than 4m is used dishes may remain dirty and manufacturer’s guarantee will be void.
9
