Russell Hobbs RHSLDW1B Installation, When installing your machine, Location of the Dishwasher

Models: RHSLDW1B RHSLDW1G RHSLDW1S

1 30
Download 30 pages 33.79 Kb
Page 8
Image 8
Installation

Installation

Products must be installed in accordance with the manufacturer's safety recommendations. Failure to do so will void the manufacturer’s guarantee.

Before connecting your appliance to the mains at home, make sure to check the conformity of the voltage settings. These are specified on the information sticker attached to the appliance and/or packaging, with the usage conditions.

The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc.)

When installing your machine

After removing the packaging material from the appliance and its accessories, ensure that the dishwasher is not damaged. If you suspect any damage, do not use the appliance and contact an authorised service personal, qualified electrician or Product Care, (0845 208 8750), immediately.

Ensure you choose a suitable, safe and level place to install your machine.

We recommend this machine be installed by a qualified engineer.

Only original spare parts should be used with this machine.

Before installing, ensure the machine is unplugged.

All electrical values must match the values indicated on the rating plate.

Ensure the machine does not stand on the electricity supply cable.

Never use an extension cable or multiple power point cable when using the appliance.

Note

Before using the machine, run a full cycle with the machine empty

Location of the Dishwasher

When determining the place to put your machine, ensure there is sufficient room to fully open the dishwasher door.

Do not install the machine where the room temperature is likely to drop below 0°C.

Before positioning, remove the machine from its packaging taking care to follow warning instructions attached.

Position the machine close to a water tap or drain.

When moving the machine ensure you do not grip the door or panel.

Ensure there is sufficient room around the machine to allow it to be moved for cleaning purposes.

Ensure that the water inlet hose does not become compressed while positioning the machine. Also, make sure that the machine does not stand on the electrical cable.

Ensure the machine is level when placed on the floor. Adjust the feet by turning them clockwise to raise the height of the machine, and anti-clockwise to reduce the height of the machine. Failure to ensure the machine is level may result in the door not closing properly and the machine to sway (this is not recommended and will void the guarantee).

8

Page 8
Image 8
Russell Hobbs RHSLDW1B, RHSLDW1S, RHSLDW1G Installation, When installing your machine, Location of the Dishwasher