Russell Hobbs manual Operation of X-10SW Handheld Sprayer

Operating and Maintenance Instructions

Operation of X-10SW Handheld

Sprayer

The X-10SW must be used in strict conformation with the

Department Operational Procedures.

1.Place the X-10C chemical cylinder in the fabric carrier.

2.Fasten the Velcro flap and hose straps so the bottle cannot slip out of the fabric carrier.

3.Place the carrier on your back in the same manner that you would any backpack.

4.Fasten the chest strap and arrange the hose for either right-hand or left-hand operation as desired.

5.Verify that the spray wand pistol grip safety lever is in the safe position before proceeding. Examine the spray wand tip to be sure that it is properly seated in the quick release connector. If not properly seated, the tip can be shot off the pistol grip with the first chemical shot.

6.If you are using a “Salinas” or wide-angle fog tip, verify that the tip is properly oriented to provide the desired spray pattern.

NOTE: The spray tips can rotate during repeated use or close contact, so check tip orientation before each use.

After Using or When Refilling the X- 10SW with X-10C chemical cylinder Attached

After using the X-10SW, immediately close the X-10C chemical cylinder valve to stop further chemical flow to the wand. After closing the X-10C valve, the handheld wand must be sprayed in a

5