Russound CA4.4pi, 4-Zone Zone Pre-AmpOutputs, 7.4 12-VoltTrigger Output, Mute Inputs

7.3 Zone Pre-Amp Outputs
In applications where more power than the 20 watts		ZONE PREAMP OUTPUTS
per channel is desired, connect the CA4.4pi to an					R	POWER
					L
external amplifier. Using standard RCA connectors,	4	3	2	1

wire from the pre-amp outputs of the CA4.4pi to the

amplifier's inputs. A typical application for more power is when connecting an outside zone where the audio power requirements would be much greater than an inside zone.

7.4 12-Volt Trigger Output

The 12 volt trigger is engaged when any of the zones are on. The trigger can be used to engage any 12 volt triggered accessory, such as a triggered AC outlet or audio amplifier. The connection for the trigger is made by an 1/8” phono jack. The tip is (+) and sleeve is (-).

7.5 Mute Input

12V TRIG

POWER

When used with the optional Doorbell or Telephone interface, the Mute Input mutes the audio to the speakers for six seconds when either the doorbell is used or when the telephone rings. The connection for the Mute Input is made by a 1/8” male jack. The tip is (+) and the sleeve is (-).

AC DIM-1 Doorbell Interface
Power	POWER	DOORBELL INTERFACE
	+12V DC	DB3 DB2 DB1	TRANS
		TRIG OUT
	TRIG
To Trigger Input on CA4.4pi			To Doorbell

AC TIM-1 Telephone Interface

Power	POWER
		TELEPHONE INTERFACE
	+12V DC	PHONE LINE
		TRIG OUT
	TRIG
To Trigger Input on CA4.4pi		To Phone Line

7.6 Connecting The Infra-red Components

•In order for your CA4.4pi to transmit the IR signal from the keypads to a source, an emitter must be connected from the IR outputs marked 1-4. Each of these outputs are wired in series and must be connected in consecutive order. For example, the #1 emitter output must be connected in order for the # 2 emitter output to transmit the IR command.

Zone Pre-Amp	Voltage Selector
Outputs	Switch

ZONE PREAMP OUTPUTS

~220-240VAC ~110VAC

R 6 7 8

L

4	3	2	1	WARNING : SHOCK HAZARD –
				DO NOT OPEN
TELE-			DOOR	AVIS : RISQUE DE CHOC	~110VAC
				ELECTRIQUE – NES PAS OUVRIR.	~220-240VAC
PHONE		MUTE	BELL	SERIAL #	~50-60Hz
					400W
		INPUT

VOLTAGE FUSE

110V F4A

220-240V F2A

Mute Inputs	AC110/240	Fuse
	Input	Holder

5