Russound CA4.4pi, 4-Zone Installing the LRN Keypads, Speaker Installation, Finally, Operation

8.2 Installing the LRN Keypads

INTERCONNECT CABLE

•Connect the CA4.4 LRN’s Interface cable to the 16 pin header located on the CA4.4 KP. Note the location of the red stripe.

•Mount the keypads into double gang box and attach the double gang Decora plate.

CA4.4 LRN

9. Speaker Installation

•If you are installing in-wall speakers, follow the instructions provided with your speakers for mounting.

•Connect each speaker wire to the correct polarity (+,-).

RED

STRIPE

8 7 6 5 4 3 2 1

RED

STRIPE

CA4.4 KP

Finally!!!

•Make sure that the voltage selector is on the correct

current for your country, either 110V or 220V - +

•Power up by plugging in all power cords and turning the CA4.4pi and sources on.

10.Operation

•Power switch - When the power switch is engaged, the CA4.4pi power indicator will be lit an amber color. The CA4.4pi should be left on at all times. The unit will consume very little power unless the zones are on and active. The unit has a stand-by mode when the zones are inactive.

•The zone indicator will light either red for off or green for on. The zones can only be turned on from the key- pads. All functions are accessed through the keypad only.

Operating The CA4.4 KP Keypad

•Power ON / OFF - This knob on the CA4.4 KP keypad controls all functions except for the IR management. To turn the unit on, simply turn the control knob clock-wise. You will feel and hear a click verifying that the unit has been acti- vated. The lights on the keypad will also illuminate to verify the zone is now on. Note - The CA4.4pi front panel zone-management lights also informs you which zone is On or Off.

•Volume UP / DOWN - Once the unit is on, the knob can be used to adjust the volume. To adjust the volume up, turn the knob clockwise, and to turn the vol- ume down, turn counter-clockwise.

•Source Selection - By pressing the knob, the zone will scroll through the four sources connected to the CA4.4pi. The keypad has four lights (LED's) that indi- cate the source selected.

•IR Source Control - The IR window repeats all source commands from the source component's remote through the CA4.4pi and 845 emitters. Most IR receivers have a range of 20' at an angle of 60-65 degrees.

TUNER

CD	S
	O
	U
TAPE	R
	C
	E
AUX

•ON / OFF

•VOLUME

•SOURCE

SOURCE

REMOTE SENSOR

7