8.2 Installing the LRN Keypads
•Connect the CA6.4 LRN’s Interface cable to the 16 pin header located on the CA6.4 KP Interface. Note the location of the red stripe.
•Mount the keypads into double gang box and
attach the double gang Decora plate.
INTERCONNECT
CA6.4 LRN CABLE
RED
STRIPE
CA6.4 KP
9. Speaker Installation
•If you are installing
•Connect each speaker wire to the correct polarity
- +
Finally!!!
•Power up by plugging in all power cords and turning the CA6.4 and sources on.
10.Operation
•Power switch - When the power switch is engaged, the CA6.4 power indicator will be lit an amber color. The CA6.4 should be left on at all times. The unit will consume very little power unless the zones are on and active. The unit has a
•The zone indicator will light either red for off or green for on. The zones can only be turned on from the key- pads. All functions are accessed through the keypad only.
Operating The CA6.4 Keypad
•Power ON / OFF - This knob on the CA6.4 keypad controls all functions except for the IR management. To turn the unit on, simply turn the control knob clock- wise. You will feel and hear a click verifying that the unit has been activated.
The lights on the keypad will also illuminate to verify the zone is now on. Note - The CA6.4 front panel
•Volume UP / DOWN - Once the unit is on, the knob can be used to adjust the volume. To adjust the volume up, turn the knob clockwise, and to turn the vol- ume down, turn
•Source Selection - By pressing the knob, the zone will scroll through the four sources connected to the CA6.4. The keypad has four lights (LED's) that indicate the source selected.
•IR Source Control - The IR window repeats all source commands from the source component's remote through the CA6.4 and 845 emitters. Most IR receivers have a range of 20' at an angle of
TUNER
CD | S |
O | |
| U |
TAPE | R |
C | |
| E |
AUX |
|
•ON / OFF
•VOLUME
•SOURCE
SOURCE
REMOTE SENSOR
7
