Ryobi 155r manual Replacing The Charger, Cleaning The Unit, Storing The Unit

MAINTENANCE AND REPAIR INSTRUCTIONS

REPLACING THE CHARGER

Replace the charger if it is damaged, or if the barrel connector or cord become damaged, or if the barrel connector is not connecting to the unit properly.

CAUTION: Only use the type of charger specified for this unit. Any other type may cause damage to the unit, batteries and possible injury.

Your trimmer requires a Ryobi #182534 12V charger and #180295 charging station. The charging instructions refer only to these parts.

NOTE: If you are using the optional Battery and Charger Accessory Kit to charge your battery. Read and follow all instructions in the manual that comes with the kit to set up and properly charge your battery.

1.Unplug the charger from the wall outlet and remove the unit from the charging station.

2.Remove the screw from the clamp holding the barrel connector in place using a standard or T-20 Torx bit screwdriver (Fig. 19).

3.Remove the barrel connector from the slot and replace charger, if needed.

4.Insert the narrow side of the barrel connector wire into the groove in the slot of the charging station. Ensure the barrel connector is inserted correctly and secure (Fig. 19).

5.Reinstall the clamp and screw.

6.Plug the charger into the wall outlet. Refer to Charging the Unit for charging instructions.

Barrel Connector

Edge of Barrel

Connector Wire

Clamp

Groove

Charging Station

Charger

Fig. 19

CLEANING THE UNIT

WARNING: Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in operating condition. To prevent serious personal injury, take extra precautions and care when performing maintenance, cleaning or servicing the unit.

WARNING: To prevent serious personal

injury, remove or disconnect the battery before servicing, cleaning, changing add-on attachments or removing material from the unit.

•Clean the unit using a damp cloth with a mild detergent.

•Do not use any strong detergents on the plastic housing or the handle. They can be damaged by certain aromatic oils such as pine and lemon, and by solvents such as kerosene. Moisture can also cause a shock hazard. Wipe off any moisture with a soft dry cloth.

•Use a small brush or the air discharge of a small vacuum cleaner brush to clean the air vents on the battery housing and motor housing.

•Keep the air vents free of obstructions

STORING THE UNIT

Clean the unit thoroughly before storing it. Hang

the unit on the charging station. Store the unit in a dry, well-ventilated area, locked-up or up high, out of the reach of children.

To maintain the life of the battery, only store the unit in a place where temperatures do not exceed 100°F or drop below 40°F.

ACCESSORIES AND REPLACEMENT PARTS

Cutting Attachment Shield . . . . . . . . . . . . . . . . . 180293

Replacement Line . . . . . . . . . . . . . . . . . . . . . . . 610375

Replacement Line Cartridge . . . . . . . . . . . . . . . . 180292

Inner Reel Spring . . . . . . . . . . . . . . . . . . . . . . . . 180374

Bump Head Cover . . . . . . . . . . . . . . . . . . . . . . . 180376

Charger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 182534

Charging Station . . . . . . . . . . . . . . . . . . . . . . . . . 180295

12 Volt Battery Pack . . . . . . . . . . . . . . . . . . . . . . 182391

Battery and Charger Accessory Kit (optional) . . . 300028

14