ASSEMBLY INSTRUCTIONS
THROTTLE CABLE ASSEMBLY
1.Wrap the throttle wire once around the handlebar (Fig. 8).
2.Depress the throttle trigger and locate hole for the throttle wire (Fig. 9).
3.With the throttle trigger depressed, place the barrel end of the throttle wire inside the hole of the trigger (Fig. 10).
4.Release the throttle trigger and guide the cable up into the slot of the trigger housing.
5.Push the throttle cable housing into the trigger housing until it snaps into place (Fig. 11).
6.Route the throttle cable through the clip on the right handlebar mounting bracket (Fig. 12).
NOTE: Ensure the throttle cable is fitting into the guide at the carburetor plate on the engine. If it does not, the throttle will not work properly (Fig. 8).
Carburetor
Plate Guide
Throttle Cable
Fig. 8
Throttle Wire Hole
Fig. 9
Throttle
Wire Slot
Fig. 10
Fig. 11
Throttle
Cable
Engine
Mounting
Bracket
Fig. 12
10
