ASSEMBLY INSTRUCTIONS (Continued)
INSTALLING THE BRUSH BLADE
1.Remove the line guard.
2.Insert the locking rod into the locking rod slot. Rotate the line spool clockwise. Remove the line spool and retainer washer from the shaft (Fig. 6).
Line Guard |
Locking |
Rod Slot |
Blade Guard |
Locking Rod |
Retainer Washer |
Bump Head/ |
Line Spool |
Fig. 6
4.Install the blade, washer, and lock nut. Insert the locking rod into the locking rod slot (Fig. 7). Make sure that the blade stays flat against the washer while tightening the lock nut counterclockwise until it is
5.If you have a torque wrench, tighten the lock nut to
If you do not have a torque wrench, thread the lock nut onto the brush blade by hand as tightly as possible (Fig. 8). Using an
The blade tooth cover can now be removed.
3.Make sure that you have all of the parts necessary to install the brush blade (Fig. 7). Do not remove the blade tooth cover off of the blade. Always wear gloves while handling or installing the blade.
Locking
Rod Slot
Blade Guard
Locking Rod |
| |
Blade |
| |
Retainer Washer |
| |
Lock Nut | Blade Tooth | |
Cover | ||
|
Fig. 7
Fig. 8
1/2-3/4 turn
Fig. 9
8