Ryobi A25RT02 manual Attaching the Vacuum Hose, Clamping the Router Table to a Work Bench

ASSEMBLY

ATTACHING THE VACUUM HOSE

See Figure 18.

The vacuum port molded into the fence will accept either a 1-1/4 in. or 2-1/2 in. vacuum attachment.

CLAMPING THE ROUTER TABLE TO A WORK BENCH

See Figures 19.

Unplug the router table and/or the router.

Place the router table right side up on a sturdy work surface; e.g., leg stand, workbench, counter top.

Using a clamp, insert the top front of clamp through the opening in the router table leg.

Tighten clamp securely.

MOUNTING THE ROUTER TABLE TO A WORK BENCH

See Figure 20.

Unplug the router table and/or the router.

Place the router table right side up on a sturdy work surface; e.g., leg stand, workbench, counter top.

Mark the holes with a pencil.

Remove the router table.

Drill four holes through the work surface.

Place the router table back on the work surface, align- ing the holes in the table legs with the holes in the work surface.

NOTE: Position the router table surface at approximately hip height.

Insert four bolts (not included, 1/4-20 recommended) and tighten securely with flat washers, lock washers, and hex nuts (not included).

VACUUM PORT

Inch

VACUUM HOSE

inch

WORK TABLE CLAMP

inch

Fig. 18

Fig. 19

BOLTS

FLAT

WASHER

HEX NUT	LOCK	WORK TABLE
	WASHER	Fig. 20

16