GENERAL SAFETY RULES
INSPECT TOOL CORDS PERIODICALLY. If damaged, have repaired by a qualified service technician at an authorized service facility. The conductor with insulation having an outer surface that is green with or without yellow stripes is the
INSPECT EXTENSION CORDS PERIODICALLY and replace if damaged.
KEEP TOOL DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always use a clean cloth when cleaning. Never use brake fluids, gasoline,
STAY ALERT AND EXERCISE CONTROL. Watch what you are doing and use common sense. Do not operate tool when you are tired. Do not rush.
DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF. Have defective switches replaced by an authorized service center.
DO NOT OPERATE A TOOL WHILE UNDER THE INFLUENCE OF DRUGS, ALCOHOL, OR ANY MEDICATION.
WHEN SERVICING use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.
USE ONLY RECOMMENDED ACCESSORIES listed in this manual or addendums. Use of accessories that are not listed may cause the risk of personal injury. Instructions for safe use of accessories are included with the accessory.
SPECIFIC SAFETY RULES
FORYOUROWNSAFETY,read this router table operator’s manual and the router manual before operating the router or using the router table.
ALWAYS USE THE ARTICULATING ROUTER CUTTER BIT GUARD.
WHEN USING THE ROUTER ON THE ROUTER TABLE, the router must be plugged into the router table switch outlet.
KEEP HANDS AWAY FROM CUTTING AREA. Do not reach underneath the table or in the cutting path with your hands or fingers at any time while the tool is connected to a power source.
DO NOT USE AWKWARD HAND POSITIONS.
FIRMLY CLAMP OR BOLT THE ROUTER TABLE TO A WORK SURFACE so that the router table surface is approximately hip height.
ALWAYS FEED WORKPIECE AGAINST ROTATION OF CUTTER.
INSPECT FOR AND REMOVE ALL NAILS FROM LUM- BER BEFORE ROUTING. Following this rule will reduce the risk of serious personal injury.
KEEP FINGERS AWAY FROM REVOLVING CUTTER, USE FIXTURES WHEN NECESSARY.
ALWAYS SUPPORT WORKPIECE FIRMLY AGAINST TABLE AND FENCE.
IF THE POWER SUPPLY CORD IS DAMAGED, it must be replaced only by the manufacturer or by an authorized service center to avoid risk.
SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct others who may use this tool. If you loan someone this tool, loan them these instructions also.
4
