Ryobi BE321VS manual Variable Speed, Proper Hand Placement, Turning ON/OFF the Sander, To F

OPERATION

VARIABLE SPEED

See Figure 2.

The sander has a variable speed control dial, A (slow) to F (fast), designed to allow operator control of belt speed. To increase belt speed, turn the variable speed control dial to a higher setting. Turn to a lower setting to decrease belt speed. Refer to the chart on page 10 for proper speed se- lections.

PROPER HAND PLACEMENT

See Figure 3.

For ease of operation the sander has a front handle and a rear handle. These handles allow two-hand operation which aid in maintaining control, keeping sander level with workpiece, and keeping hands clear of sanding belt. When operating the sander always hold the front handle with the left hand and the rear handle with the right hand as shown.

WARNING:

Keep hands and fingers clear of moving sanding belt, front pulley, and drive roller assembly. Failure to do so will result in the sanding of the hands or fingers.

VARIABLE SPEED

CONTROL DIAL

(A TO F)

Fig. 2

WARNING:

Do not let your fingers rest over the front or right edge of the sander. If the sanding belt were to run off, or if it were not properly adjusted, your fingers could come in contact with the moving sanding belt resulting in possible serious injury.

TURNING ON/OFF THE SANDER

See Figure 4.

nTo turn on the sander: Depress the switch trigger.

nTo turn off the sander: Release the switch trigger.

REAR

HANDLE

KEEP HANDS AND FINGERS AWAY

FROM THESE AREAS AT ALL TIMES

FRONT

HANDLE

Fig. 3

SWITCH
TRIGGER	Fig. 4

11