ADJUSTMENTS
To adjust the lasers in a rotational direction:
nRemove the blade.
n Plug in the saw.
n Rest the back of the base on scrap workpiece.
n Insert a flathead screwdriver into the laser barrel slot. n Turn laser on.
NOTE: DO NOT look directly into the laser beam.
nTurn the barrel left or right as necessary.
nSince blade thicknesses vary, always make a trial cut in scrap workpiece to ensure an accurate cut.
nCheck for proper alignment.
n Repeat as necessary until laser is aligned.
WARNING:
Use of controls or adjustments or performance of pro- cedures other than those specified herein could result in hazardous radiation exposure.
������
Complies with 21CFR parts 1040.10
and 1040.11
RYLD
|
|
|
| Fig. 29 |
|
| RYLD | ||
Complies with 21CFR parts 1040.10 and 1040.11 | ||||
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes, commu- tators, etc. Consequently, we do not recommended using this tool for extended work on these types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrica- tion is required.
23
