OPERATION

USING THE LASER GUIDE

See Figure 14.

WARNING:

Do not stare into the laser beam or turn the laser on when the tool is not in use. Failure to heed this warning could result in possible serious personal injury.

The laser guide will generate a red laser beam on the work surface in front of the saw when turned on. The laser aids in following the line of cut when cutting the workpiece.

NOTE: The laser unit comes from the factory already installed and aligned. If the laser becomes misaligned after time, refer to the Adjustments section later in this manual.

Unplug the saw.

Mark the line to be cut on the workpiece.

Adjust the depth and angle of the cut as needed.

Plug the tool into a power supply and press the laser guide button to activate the laser.

Start the motor.

NOTE: Do not touch the blade to the workpiece until the saw has reached maximum speed.

Slowly push the saw forward into the workpiece.

NOTE: Keep the laser beam on the marked line on the workpiece for precision cutting.

Once the cut is complete, allow the saw to come to a complete stop before turning off the laser.

LED WORKLIGHT

See Figure 15.

Depress the LED worklight button to turn the LED light ON or off. Always turn the light off when the saw is not in use.

 

push in TO

laser guide

TURN ON

BUTTON

 

push in TO

TURN OFF

 

51.5

45

 

 

 

 

30

 

 

15

laser

 

 

BEAM

 

 

 

 

Fig. 14

LED

 

push in TO

WORKLIGHT

 

TURN ON

BUTTON

push in TO

TURN OFF

.5

45

 

 

30

15

lED

WORKLIGHT

Fig. 15

16

Page 16
Image 16
Ryobi CSB142LZ manual Using the Laser Guide, Turn OFF, Button, Worklight