OPERATION
REVERSIBLE
See Figure 3.
SELECTOR
REVERSE
U
N
L
O
C
K
FORWARD
Fig. 3
This tool has the feature of being reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch.
CAUTION:
To prevent gear damage, always allow chuck to come to a complete stop before changing the direction of rotation.
To stop, release switch trigger and allow the chuck to come to a complete stop.
WARNING:
Your drill should never be connected to power supply when you are assembling parts, making adjustments, installing or removing drill bits, cleaning, or when not in use. Disconnecting your drill will prevent accidental starting that could cause serious personal injury.
KEYLESS CHUCK
See Figure 4.
A keyless chuck has been provided with your drill to allow for easy installation and removal of bits. As the name implies, you can hand tighten or release drill bits in the chuck jaws. Arrows on the chuck indicate which direc- tion to rotate the chuck body in order to LOCK (tighten) or UNLOCK (release) the chuck jaws. Grasp and hold the collar of the chuck with one hand. Rotate the chuck body with your other hand. Insert drill bit straight into the chuck the full length of the jaws, and tighten securely by rotating the chuck body in a clockwise direction.
UNLOCK
CHUCK (Release) CHUCK BODY JAWS
U |
N |
L |
O |
C |
K |
DRILL BIT
LOCK (Tighten)
CHUCK
COLLAR
RIGHT
Fig. 4
WARNING:
Do not hold chuck body with one hand and use power of the drill to tighten chuck jaws on drill bit. Chuck body could slip in your hand or your hand could slip and come in contact with rotating drill bit. This could cause an accident resulting in serious personal injury.
INSTALLING BITS
See Figure 4.
nUnplug your drill.
WARNING:
Failure to unplug your drill could result in accidental starting causing serious injury.
nOpen or close the chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of your drill slightly to keep the bit from falling out of the chuck jaws.
nInsert drill bit straight into chuck the full length of the jaws as shown in figure 4.
nTighten the chuck jaws on drill bit.
nTo tighten the chuck jaws on drill bit; grasp and hold the collar of the chuck with one hand, while rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of the arrow marked LOCK to tighten chuck jaws.
nDo not use a wrench to tighten or loosen the chuck jaws.
10
