OPERATION
KNOW YOUR HAMMER DRILL
See Figure 1.
Before attempting to use your hammer drill, familiarize yourself with all operating features and safety requirements.
WARNING:
If any parts are missing do not operate your hammer drill until the missing parts are replaced. Failure to do so could result in possible serious injury.
APPLICATIONS
(Use only for the purposes listed below)
1.Hammer drilling in concrete and masonry.
2.Drilling in wood.
3.Drilling in ceramics, plastics, fiberglass, and laminates.
4.Drilling in both hard and soft metals.
5.Using driving accessories, such as driving screws with screwdriver bits.
6.Mixing paints.
AUXILIARY
HANDLE
DEPTH
GAGE CLAMP
CHUCK
| CHUCK KEY |
TO STORE | STORAGE |
VARIABLE SPEED
CONTROL SELECTOR
SWITCH
TRIGGER
CHUCK KEY
TO REMOVE
DEPTH
GAGE ROD
BUTTON
Fig. 1
WARNING:
Do not allow familiarity with your hammer drill to make you careless. Remember that a careless fraction of second is sufficient to inflict severe injury.
ELECTRICAL CONNECTION
Your hammer drill has a precision built Ryobi electric motor. It should be connected to a power supply that is 220 volts, 50 Hz only. Do not operate this tool on direct current (DC). A voltage drop of more than 10 percent will cause a loss of power and the motor will overheat. If this tool does not operate when plugged into an outlet,
Page 5
