OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot bat- tery pack cool down for approximately 30 minutes before attempting to recharge.
NOTE: This situation only occurs when continuous use of the drill causes the batteries to become hot. It does not occur under normal circumstances. Refer to “CHARGING THE BATTERY PACK” for normal recharging of batteries. If the charging assembly does not charge the battery pack under normal circumstances, return both the battery pack and charging assembly to your nearest Ryobi Authorized Service Center for electrical check.
TO INSTALL BATTERY PACK
See Figure 3.
n Place the direction of rotation selector in center po- sition.
nLocate latches on side of battery pack and depress both sides to release battery pack from the drill.
nRemove battery pack from the drill.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installa- tion of the battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 3.
n Place the direction of rotation selector in center po- sition.
nLocate latches on side of battery pack and depress both sides to release battery pack from the drill.
nRemove battery pack from the drill.
BATTERY
BATTERY PORT
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 3
12
