Ryobi HP962, HP1202M Removing Bits, Screwdriving Torque Adjustment, To Adjust Torque, BIT Storage

OPERATION

REMOVING BITS

See Figure 6.

■Place the direction of rotation selector in center position. See Figure 3. This will turn off the power to your drill.

■Loosen the chuck jaws from drill bit.

■To loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand. Note: Rotate chuck body in the direction of the arrow

marked RELEASE to loosen chuck jaws.

■ DO NOT use a wrench to tighten or loosen the chuck jaws.

■Remove drill bit from chuck jaws.

SCREWDRIVING

TORQUE ADJUSTMENT

(Driving power of your drill-driver)

When using your drill-driver for various driving aplications, it becomes necessary to increase or decrease the torque in order to help prevent the possibility of damaging screw heads, threads, workpiece, etc. In general, torque should correspond to the intensity of the screw diameter. If the torque is too high or the screws too small, the screws may be damaged or broken.

The torque is adjusted by rotating the torque adjustment ring. See Figure 8. The torque is greater when the torque adjust- ment ring is set on a higher setting. The torque is less when the torque adjustment ring is set on a lower setting.

The proper setting depends on the type of material and the size of screw you are using.

TO ADJUST TORQUE

■Identify the twenty four torque indicator settings located

on the front of your drill. See Figure 8.

■ Rotate adjustment ring to the desired setting.

•1 - 4 For driving small screws.

•5 - 8 For driving screws into soft material.

•9 - 12 For driving screws into soft and hard materials.

•13 - 16 For driving screws in hard wood.

•17 - 20 For driving large screws.

•21 - For heavy drilling.

BIT STORAGE

See Figure 9.

When not in use, bits provided with your drill can be placed in the storage area located on the top of your drill as shown in figure 9.

LEVEL DRILLING

See Figure 10.

A convenient new feature provided with your drill is a level. It is recessed in the motor housing on top of your drill. It can be used to keep drill bit level during drilling operations.

Page 10

TO DECREASE

TORQUE

01

5

TO INCREASE

TORQUE

01

5

2 0

TORQUE

ADJUSTMENT

RING

Fig. 8

SCREWDRIVER BITS

BIT

STORAGE

AREA

Fig. 9

20

LEVEL

Fig. 10