OPERATION

SPLINTER-FREE CUTTING

See Figure 12.

The base of the jig saw has a narrow slot to permit splinter- free cutting. It is especially useful when cutting plywood. This feature should only be used when making straight cuts or circle cuts. It is not for bevel cutting or plunge cutting.

NOTE: The non-orbital setting also helps reduce splintering when cutting plywood.

POSITIONING THE BASE IN THE SPLINTER-

FREE CUTTING POSITION

n Remove battery pack

n Using the 1/8 in. hex key provided, loosen base pivot

BASE

screws and slide base forward.

n Always set the cutting angle at 0° for splinter-free cutting.

 

To set cutting angle at 0°, align the 0° mark on the scale

 

with the edge of the motor housing.

 

NOTE: When setting angle at 0° for splinter-free cutting,

 

the positive stop notches on the rear of the base are not

 

used.

 

n Tighten base pivot screws securely.

 

n Remove hex key and return it to the blade storage com-

 

partment.

 

n Replace battery pack.

 

BASE PIVOT

SCREW

OPTIONAL EDGE GUIDE

See Figure 13.

An optional edge guide is available for use with the saw. It

 

can be used for making crosscuts and rip cuts.

SCALE

Remove battery pack. Insert the arm through the two slots

 

in the base of the saw as shown. Adjust edge guide to the

Fig. 9

desired width and lock in place with the edge guide screw.

EDGE GUIDE

SCREW

BASE

Fig. 10

15

Page 15
Image 15
Ryobi p520 manual SPLINTER-FREE Cutting, Positioning the Base in the Splinter Free Cutting Position, Optional Edge Guide