OPERATION
TO CROSS CUT OR RIP CUT
When making a cross cut or rip cut, align your line of cut with the outer blade guide notch on the saw base as shown in figure 17.
Since blade thicknesses vary, always make a trial cut in scrap material along a guideline to determine how much, if any, the guideline must be offset to produce an accurate cut. NOTE: The distance from the line of cut to the guideline is the amount you should offset the guideline.
WIDTH OF CUT SCALE
See Figure 18.
A width of cut scale has been provided on the base of your saw. When making straight cross cuts or rip cuts, the scale can be used to measure up to four inches to the right side of the blade. It can be used to measure up to one inch to the left side of the blade.
TOP VIEW OF SAW | GUIDELINE |
FRONT OF SAW |
|
1 |
|
0 |
|
45 |
|
1 |
|
2 |
|
3 |
|
4 |
|
BLADE |
|
GUIDE NOTCH |
|
ALIGN OUTER BLADE GUIDE NOTCH ON SAW BASE WITH | |
LINE OF CUT AS SHOWN WHEN MAKING CROSS CUTS OR | |
RIP CUTS | Fig. 17 |
BASE
ASSEMBLY
|
| 50 |
| 45 | |
| 30 |
|
| 22 |
|
| 3 |
|
| 2 |
|
| 1 | 45 |
|
| |
WIDTH OF |
| 0 |
| 1 | |
CUT SCALE
BLADE
Fig. 18
Page 15
