Ryobi RT401W Mounting the Router, Mounting Routers with Round Adapter Base Plate, Hole pattern

MOUNTING THE ROUTER

WARNING:

Always unplug router and remove router bits before mounting to router table. Remove the fence, the insert, the featherboards and the miter guide from the tabletop before mounting the router.

There are two methods for attaching routers to router table. The table will accept routers with bases up to 7" in diameter. See chart below to see whether your router will mount directly to the table or will require the use of the adapter plate provided.

NOTE: If your router is not one of those listed in the chart, place the adapter base plate on top of the router base plate and rotate until the holes in the two plates are aligned. When hole patterns line up, the mounting scheme has been identified.

Brand	Model #	Adapter
		hole pattern
	R160K, R160V
Ryobi®	R161K, R161KT	A/AB
	R162K, R165
	R180, R180PL
	R1801M
	690, 691
	693LRPK
Porter Cable®	694VK, 892	D
	893PK, 895PK
	1001, 8931
	9690LR
	26941
Milwaukee®	5615-21	D
	5616-21
	5619-20
Hitachi®	KM12VC	D
Black & Decker®	7612	F
DeWalt®	DW 610	F
	DW 616	D
	1810, 1815
Skil®	1820, 1823	E
	1825, 1835
	1845-02
	17504, 17505
	17506, 17511	E
	17515, 17528
Craftsman®
	17533, 26834
	27500, 27510	A
	27511

NOTE: If your router does not fit adapter base plate or if you wish to mount router directly to the table for greater cutting depth, remove the base plate from your router, use it as a template, and drill directly through the tabletop.

I. Mounting Routers with 7"

Round Adapter Base Plate

See Figure 9 and 10

1.Remove the base plate from router.

2.Place the adapter base plate (K) on the router base according to mounting pattern identified in chart. See Figures 9.

3.Use the screws removed from the router base plate to attach the adapter base plate to the router base. Tighten screws securely.

4.Routers with A and AB hole pattern use three counter- sink 5/16" - 18 x 3/4" screws (X), to attach the adapter base plate (K) to the router. For Ryobi routers RE600 and RE601 use three M 8 x 20 countersink screws (Y).

5.To mount Craftsman routers that use the E-hole pat- tern to the adapter plate (K), three 10" - 32 x 1/2" coun- tersink screws are required (not provided).

NOTE: Adapter base plate must be mounted to the router using countersunk flat head screws.

X/Y (3)

K

X or Y

NOTE: Countersink screws

K

Fig. 9

12