TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
| PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
|
|
|
Engine will not start | 1. | No spark. | 1. Clean or replace spark plug. Reset spark plug | |
|
|
|
| gap. Refer to Spark Plug Replacement earlier |
|
|
|
| in this manual. |
|
| 2. | No fuel. | 2. Push primer bulb until bulb is full of fuel. If bulb |
|
|
|
| does not fill, primary fuel delivery system is |
|
|
|
| blocked. Contact a service dealer. If primer bulb |
|
|
|
| fills, engine may be flooded, proceed to next |
|
|
|
| item. |
|
| 3. | Engine is flooded. | 3. Set the start lever to the START position. |
|
|
|
| Squeeze the trigger and pull the rope repeatedly |
until the engine starts and runs.
NOTE: Depending on the severity of the flooding, this may require numerous pulls of the rope.
Engine does not reach full speed and emits excessive smoke
1.Incorrect lubricant/fuel mixture.
2.Air filter screen is dirty.
3.Spark arrestor screen is dirty.
4.Spark plug fouled.
1.Use fresh fuel and the correct
2.Clean air filter screen. Refer to Cleaning Air Filter Screen earlier in this manual.
3.Contact a servicing dealer.
4.Clean or replace spark plug. Reset spark plug gap. Refer to Spark Plug Replacement earlier in this manual.
Engine starts, runs, and ac- | 1. | Idle speed screw on carburetor | 1. | Turn idle speed screw clockwise to increase idle | |
celerates but will not idle |
| needs adjustment. |
| speed. See Figure 28. | |
|
|
|
|
|
|
Line will not advance | 1. | Line is welded to itself. | 1. | Lubricate line with silicone spray. | |
|
| 2. | Not enough line on spool. | 2. | Install more line. Refer to the applicable line |
|
|
|
|
| replacement section in this manual. |
|
| 3. | Line is worn too short. | 3. | Pull lines while alternately pressing down on and |
|
|
|
|
| releasing spool retainer. |
|
| 4. | Line is tangled on spool. | 4. | Remove line from spool and rewind. Refer to |
|
|
|
|
| the applicable line replacement section in this |
|
|
|
|
| manual. |
|
| 5. | Engine speed is too slow. | 5. | Advance line at full throttle. |
|
|
|
|
| |
Spool retainer hard to turn | 1. | Screw threads are dirty or | 1. | Clean threads and lubricate with grease - if no | |
|
|
| damaged. |
| improvement, replace the spool retainer. |
|
|
|
|
| |
G r a s s w r a p s a r o u n d | 1. | Cutting tall grass at ground | 1. | Cut tall grass from the top down to prevent | |
driveshaft housing and string |
| level. |
| wrapping. | |
head | 2. | Operating trimmer at part | 2. | Operate trimmer at full throttle. | |
|
|
| throttle. |
|
|
|
|
|
|
|
|
14 — English
