OPERATION
PREPARATION FOR CUTTING
See Figures 7 - 8.
nWear
n Maintain a proper grip on the unit whenever the motor is running. Use your right hand to firmly grip the rear handle while your left hand has a firm grip on the pole shaft.
n Hold unit firmly with both hands. Always keep your left hand on the pole shaft and your right hand on the rear handle, so your body is to the left of the chain line. Never use a
n Never stand directly under the limb you are cut- ting.
nBe certain the collars are fully tightened before operating equipment; check them periodically for tightness during use to avoid serious injury.
BASIC CUTTING PROCEDURE
Follow the steps below to prevent damage to tree or shrub bark. Do not use a
nMake a shallow first cut (1/4 of limb diameter) on the underside of the limb close to the main limb or trunk.
nMake a second cut from the top side of the limb outboard from the first cut. Continue the cut through the limb until the limb separates from the tree. Be prepared to balance the weight of the tool when the limb falls.
nMake a final cut close to trunk.
NOTE: For second and final cuts (from top of limb or branch), hold front cutting guide against the limb being cut. This will help steady the limb and make it easier to cut. Allow chain to cut for you; exert only light downward pressure. If you force the cut, damage to the bar, chain, or motor can result.
nRelease the trigger as soon as the cut is com- pleted.
COLLAR
Fig. 6
LOAD SECOND CUT
FIRST CUT 
1/4 DIAMETER
FINAL
CUT
Fig. 7
CUTTING GUIDE | Fig. 8 |
|
Failure to follow proper cutting procedures will result in the bar and chain binding and becom- ing pinched or trapped in the limb. If this should happen:
nStop the motor and disconnect from power supply.
nIf the limb can be reached from the ground, lift the limb while holding the saw. This should release the “pinch” and free the saw.
nIf the saw is still trapped, call a professional for assistance.
Page 14 — English
