ADJUSTMENTS
INSTALLING BITS
See Figures 4 and 5.
■ Place the direction of rotation selector in center position. |
This will lock the switch trigger in the off position. See |
DRILL BIT | CHUCK BODY |
|
Figure 10. |
■ Open or close the chuck jaws to a point where the opening |
is slightly larger than the bit size you intend to use. Also, |
raise the front of your drill slightly to keep the bit from |
falling out of the chuck jaws. |
■ Insert your drill bit into the chuck the full length of the jaws. |
See Figure 4. |
■ Tighten the chuck jaws on the drill bit. To tighten, grasp |
and hold the collar of the chuck with one hand, while |
rotating the chuck body with your other hand. |
Note: Rotate the chuck body in the direction of the arrow |
CHUCK JAWS 
CHUCK COLLAR
RIGHT
24
0 2
5
Fig. 4
marked GRIP to tighten the chuck jaws. |
■ DO NOT use a wrench to tighten or loosen the chuck |
jaws. |
WARNING:
Do not insert drill bit into chuck jaws and tighten as shown in figure 5.This could cause drill bit to be thrown from drill resulting in possible serious personal injury or damage to the chuck.
REMOVING BITS
See Figure 4.
■Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 10.
■Loosen the chuck jaws from the drill bit.
■To loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand.
NOTE: Rotate chuck body in the direction of the arrow marked UNLOCK to loosen chuck jaws.
■Do not use a wrench to tighten or loosen the chuck jaws.
■Remove the drill bit from the chuck jaws.
NOTE: Rotate the chuck body in the direction of the arrow marked GRIP to tighten the chuck jaws. DO NOT use a wrench to tighten or loosen the chuck jaws.
24
0
2
5
WRONG | Fig. 5 |
|
Page 11
