Juniper Networks E-Series manual Installing an SRP I/O Module

Remove the SRP I/O module from its antistatic bag.

5-8

CHAPTER 5 Installing Modules

Installing an SRP I/O Module

To install an SRP I/O module:

1Ground yourself by using an antistatic wrist strap or other device.

2With a Phillips screwdriver, loosen the captive screws that secure the blank faceplate covering the empty chassis slot, if present, and remove the faceplate.

3

4Slide the module into the chassis by placing it between the guides of the selected slot and pushing the module until it stops.

Note: See figures in Chapter 1, E-Series Overview, for module locations.

5Tighten the module’s captive screws using a Phillips screwdriver. Turn both screws several times before tightening them completely to allow the module to sit correctly.

Installing an SRP Module

To install an SRP module:

1Ground yourself by using an antistatic wrist strap or other device.

Note: See figures in Chapter 1, E-Series Overview, for module locations.

2Choose the slot in which you want to install the module.

•ERX-14xx models – slot 6 or 7

•ERX-7xx models – slot 0 or 1

•ERX-310 router – slot 0

3With a Phillips screwdriver, loosen the captive screws that secure the blank faceplate covering the empty chassis slot, if present, and remove the faceplate.

4Remove the SRP module from its antistatic bag.

5Verify that the ejectors are in the open position, as shown in Figure 5-5.