Juniper Networks E-Series manual Series Router Location

Overview E-SeriesRouters

5-5

Replacing and Managing Modules Using the Software

For information about software procedures associated with replacing and managing modules, see E-Series System Basics Configuration Guide, Chapter 5, Managing Line Modules and SRP Modules.

Hot-Swapping Modules

All E-series routers support hot-swapping of modules. Hot-swapping allows you to add or remove a module without powering down the system.

Protecting Modules and Slots

Each E-series chassis has an ESD (electrostatic discharge) grounding jack. See Table 5-1for locations. To prevent damage from electrostatic discharge, connect an antistatic wrist strap to the jack when handling components.

	Antistatic
ESD grounding jack	wrist strap

Figure 5-4Connecting the wrist strap to the ERX-310 router (rear)

Table 5-1Grounding jack locations

E-Series Router	Location
ERX-14xx model	Front: inside front bezel in lower-left corner
	Rear: upper-right corner
ERX-7xx model	Rear: lower-right corner
ERX-310 router	Front: lower-left corner
	Rear: lower-right corner

g013745