Juniper Networks E-Series manual Locate the four Sodimm sockets on the SRP module see

Upgrading Memory on SRP Modules E-Series Routers

9-7

a cream ceramic connector at one edge. Some or all of the sockets may already contain SODIMMs.

1Push down on the back edge of a SODIMM to release it from the socket (see Figure 9-2).

2Gently pull up and out to disconnect the SODIMM from the connectors and remove it from the socket.

Adding New SODIMMs

1Locate the four SODIMM sockets on the SRP module (see

Figure 9-2and Figure 9-3). See the previous section to learn how to remove SODIMMs.

Cream ceramic connector

Empty SODIMM socket

SODIMM

NVS card

1.Align notches in SODIMM and connector.

2.Push SODIMM into

connector at an angle of approximately 45 degrees.

3.Push down on back edge of SODIMM until it snaps into socket.

g013451

Figure 9-2SODIMM sockets on the SRP-5 and SRP-10 module