Juniper Networks manual See , Accessing E-Series Routers, for more information about

6-8

CHAPTER 6

Cabling E-Series Routers

SRP I/O module

RS-232 10/100

BASE T

g013751

Figure 6-3ERX-310 router SRP I/O module

See Chapter 8, Accessing E-Series Routers, for more information about

management access.

Connecting to the Network

To connect the E-series router to the network:

1Insert an Ethernet cable (RJ-45) connector into the 10/100Base-T (RJ-45) port on the SRP I/O module until it clicks into place.

2Connect the other end of the cable to the appropriate Ethernet network for an out-of-band connection.

Connecting to a Console Terminal

When you connect a console directly to the E-series router SRP I/O module, use a cable appropriate for your terminal connector. The cable must have a female DB-9 connector to attach to the RS-232 port on the SRP I/O module.

To connect the console to the SRP I/O module:

1Insert the female DB-9 connector into the RS-232 port, and tighten the screws.

2Connect the other end of the cable to your terminal’s serial port (VT100/ANSI).