Juniper Networks E-Series manual Configuring Line Module Redundancy, Next Step

5-16

CHAPTER 5 Installing Modules

Verifying the Installation

To verify that the installation is complete:

1After you have cabled the system for power (see Chapter 6, Cabling E-Series Routers), turn on the power switches.

The system reboots.

2Issue the show redundancy command, and verify that the display shows the redundancy hardware.

Configuring Line Module Redundancy

For information about configuring line module redundancy, refer to

E-Series System Basics Configuration Guide, Chapter 5, Managing Line

Modules and SRP Modules.

The Next Step

After you install the modules, you can connect cables to the system. Turn to Chapter 6, Cabling E-Series Routers.