Juniper Networks E-Series manual Task 6 Mount the CD on the Network Host

Installing Software When a Firewall Does Not Exist E-Series Routers

B-11

host1#configure

Configuring from terminal or file [terminal]?

Enter configuration commands, one per line. End with CNTL/Z.

host1(config)#host hostName ipAddress ftp loginname password

7Press <CTRL-Z> to return to Privileged Exec mode.

8Use the ping command to determine whether the E-series router can now reach the network host.

host1#ping hostname

If the E-series router cannot reach the network host, verify that you performed the previous steps in this procedure correctly and that the network host is operational.

Task 6: Mount the CD on the Network Host

The way you mount the CD on the network host depends on the type of network host you use, the operating system, and the way your network is configured. To find out how to mount a CD on the network host, review the manual for the operating system, or check with your network administrator.

Task 7: Copy the Software Release File

To copy the software release file to the E-series router, use the copy command.

Note: The destination file must have a .rel extension.

For example:

host1#copy hostname:/cdrom/x-y-z/x-y-z.rel x-y-z.rel

The software release will be copied from the network host to the E-series router. This process can take several minutes.

Task 8: Save the Current Configuration

To save the current configuration, use the copy running-configurationcommand:

host1#copy running-configuration filename.cnf