Hobart Welding Products OM-240 438B manual Installation, Serial Number And Rating Label Location

. A complete Parts List is available at wwwHobartWelders.com

SECTION 5 − INSTALLATION

5-1. Serial Number And Rating Label Location

The serial number and rating information for this product is located on the back. Use rating label to determine input power requirements and/or rated output. For future reference, write serial number in space provided on back cover of this manual.

5-2. Installing Welding Generator

Movement

OR

Location / Airflow Clearance

! Do not move or operate unit where it could tip.

! Do not lift unit from end.

! Do not weld on base. Welding on base can cause fuel tank fire or explosion. Bolt unit down using holes provided in base.

! Always securely fasten weld- ing generator onto transport vehicle or trailer and comply with all DOT and other applica- ble codes.

NOTICE − Do not install unit where air flow is restricted or engine may over- heat.

.See Section 4-2for lifting eye rat- ing.

	OR		OR	Mounting:
				!
					Do not mount unit by support-
					ing the base only at the four
					mounting holes. Do not use
	18 in.				flexible mounts. Use cross-
					supports to adequately sup-
	(460 mm)
		18 in.			port unit and prevent damage
					to base.
18 in.		(460 mm)		1	Cross-Supports
(460 mm)
				Mount unit on flat surface or use

	cross-supports to support base, see
	Section 4-2.
18 in.	18 in.
	(460 mm)
(460 mm)
Mounting

1

install2 2008-01 − Ref. 800 652 / Ref. 800 477-A / 803 274-A / 804 712

OM-240 438 Page 20