. A complete Parts List is available at wwwHobartWelders.com
8-6. Adjusting Engine Speed (Subaru-Powered Units)
After tuning engine, check engine speeds with a tachometer (see table). If necessary, adjust speeds as follows:
|
| Start engine and run until warm. | ||
|
| Remove rear panel and air cleaner | ||
|
| to access idle speed adjustments. | ||
|
| Remove top cover to access weld/ | ||
2 |
| power speed adjustments. | ||
1 | Idle Speed Adjustment | |||
| ||||
|
| |||
|
| Move Engine Control switch to | ||
|
| Run/Idle position. | ||
|
| 1 | Throttle Solenoid | |
|
| 2 | Mounting Screws | |
|
| 3 | Idle Speed Screw | |
|
| Loosen mounting screws. Adjust | ||
|
| solenoid position so engine runs at | ||
|
| idle speed. If necessary, back out | ||
4 |
| idle speed screw so solenoid can | ||
| be moved to correct position. Tight- | |||
|
| |||
|
| en mounting screws. Be sure sole- | ||
6 |
| noid linkage works smoothly. | ||
| Turn idle speed screw for fine | |||
|
| |||
|
| adjustments. | ||
5 |
| Weld/Power Speed Adjustment | ||
| Move Engine Control switch to Run | |||
|
| |||
|
| position. | ||
|
| 4 | Jam Nut | |
|
| 5 | Lock Nut | |
3 |
| 6 | Weld/Power Speed | |
|
|
| Adjustment Screw | |
Loosen jam nut and lock nut. Turn adjustment screw until engine runs at weld/power speed. Tighten jam nut, and then tighten lock nut.
! Stop engine.
Reinstall air cleaner, rear panel, and top cover.
2200 − 2300 rpm
(36.6 − 38.3 Hz)
3675 − 3750 rpm
(61.3 − 62.5 Hz)
Tools Needed:
10 mm
8 mm | 244 |
