Hobart Welding Products OM-240 438B manual Connecting To Weld Output Terminals, Tools Needed 3/4

. A complete Parts List is available at www.HobartWelders.com

5-8. Connecting To Weld Output Terminals

3

2 4

5

1! Stop engine.

! Failure to properly connect

weld cables may cause exces- sive heat and start a fire, or damage your machine.

6 . Do not place anything between

weld cable terminal and cop- per bar. Make sure that the sur- faces of the weld cable termi- nal and copper bar are clean.

1 Correct Weld Cable Installation

2 Incorrect Weld Cable Installation

3 Weld Output Terminal

4 Supplied Weld Output Terminal Nut

5 Weld Cable Terminal

6 Copper Bar

Remove supplied nut from weld out- put terminal. Slide weld cable terminal onto weld output terminal and secure with nut so that weld cable terminal is tight against copper bar.

7 Work Weld Output Terminal

8 Electrode Weld Output Terminal

For Direct Current Electrode Positive (DCEP), connect work cable to Work terminal and electrode holder cable to Electrode terminal.

For Direct Current Electrode Negat- ive (DCEN), reverse cable connec- tions

Use Process Selector switch to select type of weld output (see Section 6-1).

. See Sections 6-3for typical pro- cess connections and control settings.

Tools Needed: 3/4 in.

78

244 029-A / 281 080-A / 803 778-B

OM-240 438 Page 25