13-10. Typical Connections To Supply Standby Power
! Have only qualified persons perform these connections according to all applicable codes and safety practices.
1
23
4
! Properly install and ground this equipment according to its Owner’s Manual and na-
Utility
Electrical
Service
Transfer Switch 
5
Essential
Loads
Fused
Disconnect
Switch
(If Required)
Welding
Generator
Output
tional, state, and local codes.
.
is required if generator will sup- ply standby power during emergencies or power out- ages.
1Utility Electrical Service
2Transfer Switch
Switch transfers the electrical load from electric utility service to the generator. Transfer load back to electric utility when service is re- stored.
Install correct switch (customer- supplied). Switch rating must be same as or greater than the branch overcurrent protection.
3 Fused Disconnect Switch
Install correct switch (customer- supplied) if required by electrical code.
4 Welding Generator Output
Generator output voltage and wir- ing must be consistent with regular (utility) system voltage and wiring.
Connect generator with temporary or permanent wiring suitable for the installation.
Turn off or unplug all equipment connected to generator before starting or stopping engine. When starting or stopping, the engine has low speed which causes low volt- age and frequency.
5 Essential Loads
Generator output may not meet the electrical requirements of the prem- ises. If generator does not produce enough output to meet all require- ments, connect only essential loads (pumps, freezers, heaters, etc. − See Section
