Ryobi SC180VS manual Setting the Table for Horizontal or Bevel Cutting, Screw HEX NUT

ADJUSTMENTS

SETTING THE TABLE FOR HORIZONTAL OR

BEVEL CUTTING	HEX BOLT
See Figures 8, 9 and 10.

WARNING:

Failure to turn the saw off and unplug the saw from the power source could result in accidental starting causing possible serious injury.

A bevel scale is located under the saw table as a convenient guide for setting the approximate saw table angle for bevel cutting. When greater precision is required, make practice cuts on scrap material and adjust the saw table as necessary for your requirements.

Note: When cutting at angles, the drop foot should be tilted so it is parallel to the saw table and rests flat against the workpiece. To tilt the drop foot, loosen phillips screw, tilt drop foot to the proper angle, then retighten screw.

■Loosen the table lock knob and push down on the right side of the table. If the table stop at 0°, the zero degree stop is properly set. If the table stops somewhere other than zero, then adjust the zero degree stop.

■To access the zero degree stop, loosen the table lock knob, and tilt the table with the right side all the way down. Just under the front of the saw table is the zero degree stop. See Figure 9. Loosen the hex nut and rotate the hex bolt to raise or lower the bolt as needed to adjust the zero degree stop. Be sure to check to see that the table is square to the blade.

Now, by returning the table to the zero position, the zero degree stop provides a quick reference to the preset posi- tion.

ZERO DEGREE STOP

TABLE LOCK

KNOB

BEVEL

SCALE

SCALE
INDICATOR	SCREW	Fig. 8

HEX NUT

ZERO DEGREE
STOP ASSEMBLY	Fig. 9

The zero stop assembly can be rotated to the left and down out of the way and the table can be angled up to 12˚ to the left. See Figure 10.

Note: Make sure the zero degree stop is rotated all the way down or it will contact the blade storage drawer as you angle to the left.

ZERO DEGREE

STOP ASSEMBLY

Fig. 10

Page 12