ADJUSTMENTS
WARNING:
To prevent accidental starting that could cause possible serious personal injury, turn off the saw and unplug the saw from the power source before making any adjust- ments.
DROP FOOT
See Figure 6.
To prevent workpiece from lifting, the drop foot should be adjusted so it just rests on the top of the workpiece. The drop foot should not be adjusted so that the workpiece drags. Always retighten the drop foot lock knob after each adjust- ment has been made.
■Loosen the drop foot lock knob.
■Lower or raise the drop foot to the desired position.
■Retighten the drop foot lock knob.
The tall, front part of the drop foot acts as a blade guard to prevent accidental contact with the blade.
LIGHT SWITCH
ON OFF
DROP FOOT
LOCK KNOB DROP
FOOT ROD
R
DROP FOOT
SAWDUST
BLOWER / LIGHT
SQUARING THE SAW TABLE TO THE BLADE
See Figures 7 and 8.
WARNING:
Failure to turn the saw off and unplug the saw from the power source could result in accidental starting causing possible serious injury.
■Loosen the drop foot lock knob and move drop foot rod all the way up. Retighten drop foot lock knob.
■Loosen the table lock knob to tilt the saw table until it is approximately perpendicular or at right angle to the blade.
■Place a small square on the saw table next to the blade.
■Loosen the screw holding the scale indicator. See Figure 8. Move indicator to the 0° mark and securely tighten screw. Remember, the bevel scale is a conve- nient guide but should not be relied upon for precision. Make practice cuts on scrap material to determine if your angle settings are correct.
■Adjust the drop foot to desired position and securely retighten the drop foot lock knob.
DROP FOOT
LOCK KNOB
R
DROP
FOOT
DROP
FOOT ROD
| STORAG | E | Fig. 6 |
DE |
|
|
|
BLA |
|
|
|
SAWDUST BLOWER/LIGHT
See Figure 6.
WARNING:
Failure to turn the saw off and unplug the saw from the power source could result in accidental starting causing possible serious injury.
With an easy ON/Off switch, the attached sawdust blower/ light is designed to direct air to the cutting line. Adjust the sawdust blower/light to the desired position.
STORAGE
BLADE
SMALL |
| STORAGE | TABLE |
COMBINATION | BLADE |
| |
|
| LOCK KNOB | |
SQUARE |
|
| |
|
| Fig. 7 | |
|
|
|
Page 11
