Ryobi SS50 REMOVING DEPTH ADJUSTMENT RING, ASSEMBLING CIRCLE CUTTER, ATTACHING CIRCLE CUTTER, TAB, NUT, NOTE:, SCREW, WRENCH, HANDLE, ADAPTOR

ADJUSTMENTS

REMOVING DEPTH ADJUSTMENT RING

See Figure 4.

Follow these directions when removing the depth adjustment ring.

■Place wrench in tab on depth adjustment ring.

■Depress spring-loaded tab.

■Lift depth adjustment ring off of tool.

ASSEMBLING CIRCLE CUTTER

See Figure 5.

Follow these directions when assembling the circle cutter.

■Attach handle with screw provided.

■Attach pivot point knob with nut provided.

ATTACHING CIRCLE CUTTER

See Figure 6.

Follow these directions when attaching the circle cutter.

■UNPLUG YOUR SPEED SAW.

WARNING:

Failure to unplug your Speed Saw could result in accidental starting causing serious injury.

■Assemble circle cutter if necessary. Refer to “AS- SEMBLING CIRCLE CUTTER” previously.

■Remove bit if necessary. Refer to “INSERTING/ REMOVING BITS” earlier in this manual.

■Place adaptor under depth adjustment ring. NOTE: Make sure the adaptor fits snugly.

■Place circle cutter arm on top of depth adjustment ring.

■Screw threaded ring onto adaptor, securing circle cutter arm.

■Insert bit. Refer to “INSERTING/REMOVING BITS” earlier in this manual.

TAB

WRENCH

Fig. 4

SCREW

NUT

HANDLE

PIVOT
POINT KNOB	Fig. 5
THREADED
RING
	CIRCLE
	CUTTER
	ARM
DEPTH
ADJUSTMENT
RING

ADAPTOR

Fig. 6

10