WARNING:
Your Speed Saw should never be connected to power supply when you are assembling parts, making adjustments, cleaning, performing maintenance, or when not in use. Disconnecting your Speed Saw will prevent accidental starting that could cause serious injury.
INSERTING/REMOVING BITS
See Figure 2.
Follow these directions when inserting and removing bits.
■UNPLUG YOUR SPEED SAW.
TO TIGHTEN | TO LOOSEN |
Fig. 2
WARNING:
Failure to unplug your Speed Saw could result in accidental starting causing serious injury.
CAUTION:To prevent damage to the spindle or spindle lock, always allow motor to come to a complete stop before engaging spindle lock.
■Depress spindle lock.
■Loosen collet nut by turning counterclockwise with the wrench provided.
WARNING:
If you are changing a bit immediately after use, be careful not to touch the bit or collet with your hands or fingers. They will get burned because of the heat buildup from cutting. Always use the wrench provided.
■To insert bit: Insert shank end of bit into collet.
■To remove bit: Remove bit once collet nut is loose.
NOTE: The collet is machined to precision tolerances to fit bits with 1/4 in. (6.35 mm) diameter shanks. To use bits with 1/8 in. (3.16 mm) shank bits, insert the 1/8 in. (3.16 mm) adaptor into the 1/4 in. (6.35 mm) collet.
■Tighten collet nut securely by turning clockwise with the wrench provided.
WARNING:
If the collet nut is not securely tightened, the bit may detach during use causing serious personal injury.
■Release spindle lock.
WARNING:
Do not use bits with undersized shanks. Undersized shanks will not tighten properly and could be thrown from the tool causing injury.
ADJUSTING DEPTH OF CUT
See Figure 3.
Follow these directions when adjusting depth of cut.
■UNPLUG YOUR SPEED SAW.
WARNING:
Failure to unplug your Speed Saw could result in accidental starting causing serious injury.
■Loosen adjusting knob by turning counterclockwise.
■Move depth adjustment ring to desired position .
■Tighten adjusting knob by turning clockwise.
TO TIGHTEN
TO LOOSEN
ADJUST UP OR |
|
DOWN | Fig. 3 |
|
9