STARTING/STOPPING SPEED SAW
See Figure 7.
Follow these directions when starting and stopping the Speed Saw.
To start Speed Saw: Depress the switch to the I position.
To stop Speed Saw: Depress the switch to the O position.
CAUTION:
We suggest that you practice with your Speed Saw before installing a bit and making cuts.
OPERATING SPEED SAW
See Figure 8.
Follow these directions when operating the Speed Saw.
■Hold Speed Saw firmly with both hands.
■Start Speed Saw.
■Tilt Speed Saw at a 45o angle.
■Plunge bit into material using guide ring as a pivot.
■Raise Speed Saw slowly to a 90o angle.
■Begin cutting.
USING CIRCLE CUTTER
See Figure 9.
Follow these directions when using the circle cutter.
■Assemble circle cutter if necessary. Refer to “AS- SEMBLING CIRCLE CUTTER” earlier in this manual.
■Attach circle cutter to Speed Saw if necessary. Refer to “ATTACHING CIRCLE CUTTER” earlier in this manual.
■Adjust depth of cut if necessary. Refer to “ADJUST- ING DEPTH OF CUT” earlier in this manual.
■Loosen pivot point knob.
■Move pivot point knob to desired diameter dimen- sion.
■Tighten pivot point knob.
■Start Speed Saw.
■Cut a pilot hole in the center of the intended circle.
■Line up pivot point knob with the lead hole.
■Begin cut, applying moderate, steady pressure.
■Hold the Speed Saw firmly with one hand and the handle with the other.
CAUTION:
Too much force causes heat build up, which can shorten the life of the bit.
■Work in a clockwise direction, continuing back to the starting position.
■Stop Speed Saw.
ON ()
OFF (O)
Fig. 7
Fig. 8
Fig. 9
11