Ryobi TR45 manual Direction of Feed and Thrust, Direction Feed Trimmer, Bit

OPERATION

DIRECTION OF FEED AND THRUST

See Figures 6 and 7.

The trimmer motor and cutter revolve in a clockwise direc- tion. This gives the tool a slight tendency to twist in your hands in a counterclockwise direction, especially when the motor starts.

Feed the trimmer into the workpiece from left to right. When	TRIM GRAINS
fed from left to right, the rotation of the cutter pulls the trim-
mer against the workpiece. If fed in the opposite direction,
the rotation forces of the spinning cutter will tend to throw	END FIRST
This could result in loss of control of the trimmer.
the trimmer away from the workpiece, causing kickback.
Because of the extremely high speed of cutter rotation dur-
ing a proper feeding operation, there is very little kickback
to contend with under normal conditions. However, should
the cutter strike a knot, hard grain, foreign object, etc. that
would affect the normal progress of the cutting action, there
will be a slight kickback. Kickback could be sufficient to
spoil the trueness of your cut if you are not prepared. Such
a kickback is always in the direction opposite the direction
of cutter rotation.
To guard against kickback, plan your set-up and direction
of feed so that you will always be thrusting the tool—to
hold it against whatever you are using to guide the cut—in
the same direction that the leading edge of the cutter is
moving. The thrust should be in a direction that keeps the
sharp edges of the cutter continuously biting straight into
new (uncut) wood.

DIRECTION
FEED TRIMMER
ROTATION	TRIMMERFEED DIRECTION
BIT
	BIT
	ROTATION
TRIMMER FEED
DIRECTION
	Fig. 6
GUIDE OUTSIDE

	THRUST
ROTATION	FEED

GUIDE

GUIDE INSIDE

ROTATION

GUIDE

FEED

THRUST

Fig. 7

Page 12