![](/images/new-backgrounds/1240738/24073823x1.webp)
ASSEMBLY
WARNING:
To prevent accidental starting that could cause possible serious personal injury, assemble all parts, make sure all adjustments are complete, and make sure all fasteners are secure before connecting saw to power supply. Saw should never be connected to power supply when you are assembling parts, making adjustments, installing or re- moving blades, or when not in use.
As mentioned previously your saw has been factory as- sembled and adjusted. The miter lock handle, work clamp, dust guide or dust bag, table extensions, stop block, and blade are the only parts that have to be installed.
MITER LOCK HANDLE
See Figure 7.
To install the miter lock handle, place the threaded stud on the end of the miter lock handle into the threaded hole in the control arm under miter table. Turn clockwise to tighten.
WORK CLAMP (Optional)
See Figure 8.
To install optional work clamp, part number
WARNING:
When using the work clamp with the stop block, install the clamp on the stop block side of the blade. This will eliminate the possibility of the saw catching the loose end and kicking up. Failure to heed this warning can result in serious personal injury.
15
TO | 0 |
LOOSEN | 15 |
30
45
TO
TIGHTEN
CONTROL | MITER | |
ARM | ||
TABLE | ||
|
MITER
LOCK HANDLE
Fig. 7
45
30
15
0
15
0
| WORK CLAMP | |
8 mm WORK | MITER | |
TABLE BASE | ||
CLAMP SCREW | ||
Fig. 8 |
DUST GUIDE
See Figure 9.
To install the dust guide, place the end marked INSERT over the exhaust port in the upper blade guard. Turn the guide so that the open end is facing down.
TO INSTALL BLADE
See Figures 10, 11, and 12.
WARNING:
A 10 in. (254 mm) blade is the maximum blade capacity of your saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade bolt from securing the blade on the spindle. Either of these situa- tions could result in a serious accident and can cause serious personal injury.
UPPER | DUST GUIDE |
| |
BLADE GUARD |
|
EXHAUST
PORT
15
0
15
30
45
Fig. 9
Page 12