Ryobi TS1300 Squaring the Miter Table to the Fence, Fence Miter Table, Blade Slot Framing Square

ADJUSTMENTS

SQUARING THE MITER TABLE TO THE FENCE

See Figures 13 - 16.

■Unplug your saw.

WARNING:

Failure to unplug your saw could result in accidental starting causing possible serious personal injury.

■ Push down on the saw arm and pull out the lock pin to

release the saw arm. See Figure 3.

■ Raise saw arm to its full raised position.

■ Loosen the miter lock handle approximately one-half

turn.

■ Depress the miter lock plate and rotate the miter table

until the pointer on the control arm is positioned in the

positive stop at 0°.

FENCE

MITER TABLE

45˚			45˚
30˚	15		30˚
		0˚	15˚

BLADE SLOT

FRAMING

SQUARE

VIEW OF MITER TABLE NOT SQUARE WITH FENCE, ADJUSTMENTS ARE REQUIRED

■ Release the miter lock plate and securely tighten the

miter lock handle.

■ Lay a framing square flat on the miter table. Place one

leg of the square against the fence. Place the other leg

of the square beside the blade slot in the miter table.

The edge of the square and the blade slot in the miter

table should be parallel as shown in figure 13.

■ If the edge of the framing square and the blade slot in

the miter table are not parallel as shown in figures 14

FENCE

Fig. 14

MITER TABLE

and 15, adjustments are needed.

■ Using a 6 mm hex key provided, loosen the socket head

screws securing the fence. See Figure 16. Adjust the

fence left or right until the framing square and blade slot

are parallel.

■ Retighten the screws securely and recheck the fence-

to-table alignment.

FENCE

MITER TABLE

45˚			45˚
30˚	15		30˚
		0˚	15˚

	BLADE SLOT
FRAMING
SQUARE
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED		Fig. 15
6 mm SOCKET	6 mm SOCKET
HEAD SCREW(S)	HEAD SCREW(S)

45˚			45˚
30˚	15		30˚
		0˚	15˚

FRAMING		BLADE SLOT
SQUARE
MITER		MITER
LOCK PLATE
		LOCK HANDLE
	CORRECT VIEW OF MITER
	TABLE SQUARE WITH FENCE		Fig. 13

Page 15

45 °

30°

15°

FENCE

45°

° 30

	°
0°	15

Fig. 16