Ryobi TS1351 manual Miter Fence

ADJUSTMENTS

■The edge of the square and the saw blade should be parallel as shown in figure 21.

■If the front or back edge of the saw blade angles away from the square as shown in figures 22 and 23, adjust- ments are needed.

■Loosen the socket head screws that secure the miter fence to the miter table. See Figure 20.

■Rotate the miter fence left or right until the saw blade is parallel with the square.

■Retighten the screws securely and recheck the blade- to-fence alignment.

Your saw has two scale indicators, one on the bevel scale and one on the miter scale. After squaring adjustments have been made, it may be necessary to loosen the indicators screws and reset them to zero. See Figure 24.

MITER
FENCE	45
	0

				45
				30
			2.5
			2
			15
45	30		15
31.62		22.5
				BLADE
				MITER
FRAMING				LOCK
				PLATE
MITER SQUARE
TABLE			MITER
	LOCK HANDLE
VIEW OF BLADE
SQUARE WITH FENCE				Fig. 21

MITER	0
FENCE	45

					45
					30
					2.5
					2
					15
		45	30		15
		31.62		22.5
					BLADE
	MITER	FRAMING
	TABLE	SQUARE
	VIEW OF BLADE NOT SQUARE WITH
	FENCE, ADJUSTMENTS ARE REQUIRED					Fig. 22
MITER	45	0

FENCE

45

30

2.5 2

15

45	30		15
31.62		22.5

BLADE

MITER FRAMING

TABLE SQUARE

VIEW OF BLADE NOT SQUARE WITH

FENCE, ADJUSTMENTS ARE REQUIRED Fig. 23

45

4 5

31.			.6
6	30		31
			30
	22.		.5
	5		22
	15	0	15

INDICATOR

BEVEL

SCALE INDICATOR

POINT

INDICATOR

SCREW

45

15

SCREW

SCALE MITER INDICATOR SCALE

0

SCALE

INDICATOR

Fig. 24

Page 17