ADJUSTMENTS

SQUARING THE MITER TABLE TO THE FENCE

See Figures 18 through 22.

Follow these directions to square the miter table to the fence.

■Unplug the saw.

WARNING:

Failure to unplug the tool could result in accidental starting causing possible serious personal injury.

■Push down on the saw arm.

■Pull out the lock pin to release the saw arm.

■Raise the saw arm to its full raised position.

■Loosen the miter lock handle by rotating it approxi- mately one-half turn.

■Loosen the socket head screws securing the miter lock lever.

■Grasp the miter lock handle and rotate the miter table until the miter pointer is positioned at 0°.

■Tighten the miter lock handle securely.

■Tighten the socket head screws to secure the miter lock lever.

■Lay a framing square flat on the miter table.

■Place one leg of the square against the fence.

■Place the other leg of the square beside the zero clearance throat plate in the miter table.

NOTE: The edge of the square and the zero clearance throat plate in the miter table should be parallel. If the edge of the framing square and the zero clearance throat plate in the miter table are not parallel, adjustments are needed. Continue as follows.

■Loosen the socket head screws securing the fence.

■Adjust the fence until the framing square and zero clearance throat plate are parallel.

■Retighten the screws securely and recheck the fence- to-table alignment.

PULL OUT

LOCK PIN

30

15

PUSH DOWN

ON ARM

Fig. 18

MITER LOCK

HANDLE

SOCKET

HEAD

SCREW

Fig. 19

30

0

15

 

MITER

POINTER

Fig. 20

20