UNPACKING
INFORMATION
We have shipped the miter saw completely assembled except for the blade, miter lock handle, dust guide/dust bag, table extensions, and stop block.
■Remove the loose parts from the box. Make sure that all items listed in the loose parts list are in- cluded.
■Remove the packing materials from around the saw.
■Lift the saw carefully from the box and place it on a level work surface.
NOTE: The saw is heavy. Ask for assistance if necessary.
■Do not discard the packing material until you have carefully inspected the tool, identified all loose parts, and satisfactorily operated the tool.
■The saw is shipped with the saw arm locked in the down position. To release the saw arm, push down on the top of the saw arm and pull out the lock pin. Apply hand pressure on the saw arm to prevent sudden rise upon release of the lock pin.
■If any parts are damaged or missing, please call
■Inspect all parts carefully to make sure no breakage or damage occurred during shipping.
WARNING:
If any parts are missing do not operate the tool until the missing parts are replaced. Failure to do so could result in serious personal injury.
NOTE: The compound miter saw has been adjusted at the factory for making very accurate cuts. However, some of the components might have been jarred out of alignment during shipping. Also, over a period of time, readjustment will probably become necessary due to wear. After unpacking your saw, check the saw adjustments before you begin using the saw. Make any readjustments that are necessary and periodically check the parts alignment to make sure that the saw is cutting accurately. Refer to ADJUSTMENTS later in this manual.
LOOSE PARTS LIST
1.Saw blade
2.Miter lock handle
3.Dust bag
4.Dust guide
5.Stop block
6.Small wing screw
7.Clamp brackets (2)
8.Clamp bracket screws (2)
9.Table extensions (2)
10.Work clamp
11.Hex blade wrench
3
11
1
4
2
9
6
10
5
7
8
7