Ryobi TS1550 INSTALLING THE DUST BAG, INSTALLING THE TABLE EXTENSIONS, INSTALLING THE STOP BLOCK

ACCESSORIES

WARNING:

To prevent accidental starting that could cause possible serious personal injury, assemble all accessories for the saw before connecting it to a power supply. Disconnecting the miter saw will prevent accidental starting that could cause serious personal injury.

INSTALLING THE DUST BAG

See Figure 25.

The dust bag fits over the exhaust port on the upper blade guard.

Follow these directions to install the dust bag.

■Remove the dust guide from the exhaust port.

■Squeeze the two metal clips to open the mouth of the

bag.

■ Slide the bag onto the exhaust port. ■ Release the clips.

The metal ring in the bag should lock in between the grooves on the exhaust port.

For more efficient operation, empty dust bag when no more than half full. This will permit better air flow through the bag.

INSTALLING THE TABLE EXTENSIONS

See Figure 26.

Follow these directions to install the table extensions.

■ Insert the ends of the extensions into the two holes in each side of the base.

■ Position a clamp bracket under each table extension beneath the miter table.

■ Secure each clamp bracket with a clamp bracket screw by threading the screw through the clamp bracket and tightening it against the bottom of the miter table.

INSTALLING THE STOP BLOCK

See Figure 27.

The stop block is useful as a stop for cutting multiple pieces the same length. You can install it on either table extension on either side of the saw base.

Follow these directions to install the stop block.

■Slide the stop block on the back arm of either table extension.

■Insert the table extension into the saw base.

■Adjust the stop block the desired distance from the blade for the cut to be made.

Fig. 25

Fig. 26

23