ADJUSTMENTS
POSITIVE STOP |
|
|
ADJUSTMENT |
| POSITIVE STOP |
SCREW FOR |
| |
| ADJUSTMENT | |
0° ANGLES | LOCK NUT(S) | |
| SCREW FOR |
| 45° ANGLES |
BEVEL LOCK KNOB | Fig. 28 |
|
PIVOT ADJUSTMENTS
Note: These adjustments were made at the factory and normally do not require readjustment.
TRAVEL PIVOT ADJUSTMENT
The saw arm should rise completely to the up position by itself.
If the saw arm does not raise by itself or if there is play in the pivot joints, have saw repaired by at your nearest
RYOBI AUTHORIZED SERVICE CENTER.
BEVEL PIVOT ADJUSTMENT
Your compound miter saw should bevel easily by loos- ening the bevel lock knob and tilting the saw arm to the left.
If movement is tight or if there is play in the pivot, have saw repaired by at your nearest RYOBI AUTHORIZED
SERVICE CENTER.
WARNING:
Do not start your compound miter saw without checking for interference between the blade and the miter table support. Damage could result to the blade if it strikes the miter table support during operation of the saw.
APPLICATIONS
(Use only for the purposes listed below)
Cross cutting wood and plastic.
Cross cutting miters, joints, etc. for picture frames, moldings, door casings, and fine joinery.
Note: The blade provided is fine for most wood cutting operations, but for fine joinery cuts or cutting plastic, use one of the accessory blades available from your Ryobi dealer.
OPERATION
WARNING:
Before starting any cutting operation, clamp or bolt your miter saw to a workbench. Never operate your miter saw on the floor or in a crouched position. Failure to heed this warning can result in serious personal injury.
WARNING:
To avoid serious personal injury, keep your hands outside the no hands zone; at least 3 in. (7.6 cm) from blade. Never perform any cutting operation freehand (without holding workpiece against the fence). The blade could grab the workpiece if it slips or twists.
CUTTING A SLOT IN THE ZERO CLEARANCE THROAT PLATE
In order to use your compound miter saw, you must cut a slot through the zero clearance throat plate to allow for blade clearance. To cut the slot, set your saw at 0° miter, turn saw on and allow the blade to reach full speed, then carefully make a straight cut as far as it will go through the throat plate. Turn your saw off and allow the blade to come to a complete stop before raising the saw arm.
Next, adjust the bevel angle to 45°, turn your saw on and allow the blade to reach full speed, then carefully make another cut through the zero clearance throat plate. The slot in the throat plate will then be wide enough to allow the blade to pass through it at any angle from 0° to 45°.
Page 19
