![](/images/new-backgrounds/1283571/28357133x1.webp)
ADJUSTMENTS
The edge of the square and the saw blade should be parallel as shown in figure 21.
If the front or back edge of the saw blade angles away from the square as shown in figures 22 and 23, adjust- ments are needed.
Loosen the socket head screws that secure the miter fence to the miter table. See Figure 20.
Rotate the miter fence left or right until the saw blade is parallel with the square.
Retighten the screws securely and recheck the blade-
Your saw has two scale indicators, one on the bevel scale and one on the miter scale. After squaring adjustments have been made, it may be necessary to loosen the indicators screws and reset them to zero. See Figure 24.
MITER
FENCE
| BLADE |
FRAMING | MITER |
LOCK | |
MITER SQUARE | PLATE |
TABLE |
|
MITER |
|
LOCK HANDLE |
|
VIEW OF BLADE |
|
SQUARE WITH FENCE | Fig. 21 |
30 |
| 30 |
|
| |
15 | 0 | 15 |
|
|
INDICATOR
SCREWMITER
SCALE
SCALE
INDICATOR
Page 17
MITER
FENCE
BLADE
MITER FRAMING
TABLE SQUARE
VIEW OF BLADE NOT SQUARE WITH |
|
FENCE, ADJUSTMENTS ARE REQUIRED | Fig. 22 |
|
MITER
FENCE
BLADE
MITER FRAMING
TABLE SQUARE
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED Fig. 23
BEVEL | INDICATOR | |
SCALE | ||
POINT | ||
| ||
| INDICATOR | |
| SCREW | |
45 |
| |
15 |
| |
| 0 |
SCALE
INDICATOR
Fig. 24