Ryobi TS230 warranty Squaring the Miter Table to the Fence

ADJUSTMENTS

SQUARING THE MITER TABLE TO THE FENCE

See Figures 13 - 16.

■Push down on the saw arm and pull out the lock pin to release the saw arm.

■Raise saw arm to its full raised position.

■Loosen the miter lock handle approximately one-half turn.

■Depress the miter lock plate and rotate the miter table until the pointer on the control arm is positioned at 0° .

■Release the miter lock plate and securely tighten the miter lock handle.

■Lay a framing square flat on the miter table. Place one leg of the square against the fence. Place the other leg of the square beside the zero clearance throat plate in the miter table. The edge of the square and the zero clearance throat plate in the miter table should be parallel as shown in figure 13.

■If the edge of the framing square and the zero clear- ance throat plate in the miter table are not parallel as shown in figures 14 and 15, adjustments are needed.

■Using the 5 mm hex key (allen wrench) provided, loosen the socket head screws located under the miter table. See Figure 16. Adjust the miter table left or right until the framing square and zero clearance throat plate are parallel.

■Retighten the screws securely and recheck the fence- to-table alignment.

FENCE

MITER TABLE

4	˚
5
˚	5
4	4
0˚	40˚
30˚
	30˚
20˚	20˚
0˚	10˚

ZERO CLEARANCE

FRAMING THROAT PLATE

SQUARE

VIEW OF MITER TABLE NOT SQUARE WITH FENCE, ADJUSTMENTS ARE REQUIRED Fig. 14

FENCE

MITER TABLE

45˚	40˚	45˚
		40˚
	30
		30˚
	˚
	20˚	20˚
	0˚	10˚

ZERO CLEARANCE

FENCE

MITER TABLE

FRAMING SQUARE

THROAT PLATE

45˚	40˚			45˚
			40˚
	30˚
			30˚
	0˚	0˚	20˚
			10˚

FRAMING

SQUAREZERO CLEARANCE THROAT PLATE

MITER

LOCK PLATEMITER LOCK HANDLE

CORRECT VIEW OF MITER
TABLE SQUARE WITH FENCE	Fig. 13

Page 15

VIEW OF MITER TABLE NOT SQUARE WITH FENCE, ADJUSTMENTS ARE REQUIRED Fig. 15

5 mm SOCKET

HEAD SCREW(S)

BOTTOM VIEW OF MITER TABLE Fig. 16